WINDSHIELD KIT
J050962011-05-20
GENERAL
Kit Numbers
57164-10, 57400091, 57400092
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
REMOVAL
- See Figure 1. Loosen but do not remove three screws (2) (with flat washers) securing the windshield to the fairing (1).
- Raise and remove the windshield.
INSTALLATION
| 1. | See Figure 1. Place the windshield into position between the inner and outer fairings (1) engaging the slotted holes in the windshield with the threaded bosses on the inner fairing. | |
| 2. | Tighten three screws (2) to 2.8–3.4 N·m (25–30 in-lbs). |
CARE AND CLEANING
NOTICE
Polycarbonate windshields/wind deflectors require proper attention and care to maintain. Failure to maintain polycarbonate properly can result in damage to the windshield/wind deflector. (00483e)
- Do not use benzene, paint thinner, gasoline or any other type of harsh cleaner on the windscreen/windshield. Doing so will damage the surface.
- Do not clean polycarbonate in hot sun or high temperature.
- Powdered, abrasive or alkaline cleanser will damage the windscreen/windshield.
- Sunlight reflections off of the inside curvature of a windscreen/windshield can, at certain times of the day, cause extreme heat build-up on motorcycle instruments. Exercise care in parking. Park facing the sun, place an opaque object over the instruments, or adjust the windscreen/windshield to avoid reflections.
- Do not use benzene, paint thinner, gasoline or any other cleaning agents on the rubber bushings. Doing so will damage the bushing surfaces.
NOTE
Harley-Davidson Windshield Water Repellent Treatment part number 99841-01 is approved for use on Harley-Davidson polycarbonate windshields.
| 1 | Fairing |
| 2 | Windshield screws (3) |
Figure 1. Windshield Installation