FLOATING REAR BRAKE ROTOR (DISC) KITS
J049862009-05-27
GENERAL
Kit Number
48979-10
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Loctite® 243 (blue)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
1. See the service manual for brake disc removal and disassembly procedures.
NOTICE
Do not re-use brake disc/rotor screws. Re-using these screws can result in torque loss and damage to brake components. (00319c)
2. See Figure 1. Assemble and install the new brake disc (1) following the instructions in the service manual. Place a few drops of Loctite 243 (blue) on the threads of the new chrome screws from the kit. Install the brake disc using ONLY the new chrome screws. Torque the screws to 54 N·m (40 ft-lbs).
NOTE
Avoid hard stops for the first 300 miles. Hard stops during wear-in period will gall brake discs.
SERVICE PARTS
Figure 1. Service Parts: Floating Rear Brake Rotor (Disc) Kits (Stinger Style Shown)
Table 1. Service Parts: Floating Rear Brake Rotor (Disc) Kit
Item
Description (Quantity)
Part Number
Kit, Right Rear Stinger 48979-10
1
Brake disc, rear
Not Sold Separately
2
Screw, chrome (5)
4563