1. | See Figure 1. Align extension (3) on top of the jiffy stand toe bracket (A). Mark the center of the hole location. | |
WARNING Wear safety glasses or goggles while drilling. Flying debris could result in serious eye injury. (00565b) | ||
2. | Drill jiffy stand extension mounting hole into the to bracket of the jiffy stand as follows: a. Use a center punch to create a drill point at the marked location. b. Use a 3 mm (⅛ in) drill bit and drill a pilot hole at the marked location. c. Use an 7 mm (9/32 in) drill bit to drill through the pilot hole and enlarge the hole. d. Remove any burrs left on the drilled hole. | |
3. | See Figure 1. Place extension (3) over jiffy stand toe bracket (A). Fasten extension to the toe bracket with screw (1), washers (2) and nut (4) as shown. Tighten to 8.1–10.8 N·m (6–8 ft-lbs). |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Screw | 94386-92T |
2 | Washer, chrome (2) | 94065-90T |
3 | Extension | Not Sold Separately |
4 | Locknut | 94026-92T |
Items mentioned in text, but not included in kit. | ||
A | Jiffy stand toe bracket |