12 Volt Tour-Pak Power Supply
Kit Number
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
This kit contains one 12 V auxiliary power supply.
To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)
1. See the service manual. Remove main fuse.
2. See the service manual. Remove bottom Tour-Pak® liner.
3. See Figure 1. Remove the two lower mounting screws (1) and washers (2) for the right speaker enclosure.
1Screw (2)
2Washer (2)
312 V power outlet
4Sound port
5Speaker enclosure
Figure 1. Install 12 V Power Outlet
1Distance - 1.3 in (3.3 cm)
2Distance - 2.5 in (6.4 cm)
Figure 2. Cut and Trim Tour-Pak Liner
4. Install the 12 V outlet (3) inside the Tour-Pak. Secure with previously removed screws and washers. Tighten to 2.3–2.8 N·m (20–25 in-lbs).
5. Mate the power connector [258] to the 12 V outlet connector (6).
6. See Figure 2. Remove material as necessary so that the Tour-Pak liner will fit around the power outlet. Remove the material indicated in gray as shown.
7. See the service manual. Install the Tour-Pak liner.
8. See the service manual. Install the main fuse.
The power outlet is connected to the accessory switch and will operate when the switch is ON.