0/0
HEADLAMP VIBRATION DAMPENER
J053392010-11-30
GENERAL
Kit Number
67700059
Models
This kit is designed to be installed on Springer model motorcycles with an LED headlamp installed.
Kit Contents
There are no Service Parts available with this kit.
INSTALLATION
  1. See the owner's manual and remove the headlamp retaining ring.
  2. Remove and disconnect the headlamp from the headlamp shell.
  3. See Figure 1. Install the vibration dampener (1) into the headlamp shell (2) as shown.
  4. Connect and install the headlamp into the headlamp shell.
  5. See the owner's manual and install the headlamp retaining ring.
  6. See the instruction sheet for the LED head lamp and properly adjust the LED headlamp.
1Headlamp vibration dampener
2Headlamp shell
Figure 1. Install Headlamp Vibration Dampener