PREMIUM TOUR-PAK BOTTOM LINER KITS
J057482013-02-22
GENERAL
Kit Number
53000322, 53000323
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Table 1. Kit Usage
Kits | Usage |
|---|---|
53000322 | For Chopped Tour-Pak |
53000323 | For King Tour-Pak |
These liners are not compatible with Tour-Pak® bottom floor- or wall-mounted accessories except the BOOM! Audio Bass Booster Tour-Pak Port Kit (Part No. 76000013).
Kit Contents
This kit consists of a Tour-Pak bottom liner and these instructions. There are no service parts available for this kit.
INSTALLATION
| 1. | Open the Tour-Pak lid and remove all items from the Tour-Pak base. | |
| 2. | Models with rubber mat: Remove the mat. Models with molded liner: Open the map pocket and remove the acorn nuts with flat washers. Remove the map pocket and liner. NOTE For a vehicle equipped with a BOOM! Audio Bass Booster
Tour-Pak Port Kit: Use a sharp hobby knife to cut out the two perforated circles (1) at the front corners of the new liner (see Figure 1. | |
| 3. | ALL applications: Remove the cover tether from the Tour-Pak bottom. Place the liner into the Tour-Pak. Install the cover tether through the hole (2) in the front of the liner. Tighten the screws to 2.8–4 N·m (25–35 in-lbs). |
| 1 | Perforated circle (2) |
| 2 | Tether line hole |
Figure 1. Tour-Pak Bottom Liner (King Shown)