0/0
LED BULLET FOG LAMP HARNESS
J059412014-05-15
GENERAL
Kit Number
69200864
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Separate purchase of an Engine Guard Mounted LED Bullet Fog Lamp Kit and an LED Bullet Fog Lamp Mounting Kit are required for proper installation of this kit.
Electrical Contact Lube (H-D Part No. 99861-02) or equivalent is required after battery cable disconnection.
These items are available from a Harley-Davidson dealer.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet refers to service manual information. A service manual for this year/ model vehicle is required for this installation. One is available from a Harley-Davidson dealer.
Kit Contents
See Figure 1 and Table 1.
PREPARATION
WARNING
To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)
NOTE
  • For 2007- later vehicles WITH security siren: With security fob present, turn ignition switch ON. See the service manual. After system is disarmed, turn ignition switch OFF. IMMEDIATELY remove the main fuse.
  • For 2006- earlier vehicles WITH security siren: Disarm the siren with the key fob or security code. See the service manual to remove the main fuse.
  • For vehicles WITHOUT security siren: See the service manual. Remove main fuse.
INSTALLATION
  1. Install the fog lamps and mounting brackets to the vehicle per the instructions in those kits.
  2. If NO auxiliary lamp switch is present:If an auxiliary lamp switch IS present: Access the connectors in back of the switch. Separate the connectors. Plug this harness in between the two separated connectors.
    1. See a Harley-Davidson dealer to purchase an original equipment (OE) auxiliary lamp switch for this year/ model vehicle, OR
    2. Use the Universal LED Bullet Fog Lamp Harness (Kit No. 69200863) instead of this kit.
  3. See Figure 1. Route the two harness legs and connectors (2) downward to the base of the front downtube. Plug the harness into the fog lamps.
  4. Coil up any excess wire. Use cable straps (4) to secure the harness legs to the engine guard.
COMPLETION
NOTE
To prevent possible damage to the sound system, verify that the ignition is OFF before installing the main fuse or attaching the negative battery cable.
1. Models with main fuse: See the service manual. Install main fuse. Models with main circuit breaker: See the service manual. Attach negative battery cable. Apply a light coat of petroleum jelly or corrosion retardant material to battery terminals.
WARNING
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)
2. ALL models: See the service manual. Install seat.
SERVICE PARTS
Figure 1. Service Parts, LED Bullet Fog Lamp Harness
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Wire harness, LED bullet fog
lamp (includes items 2-3)
69201111
2
  • Pin housing, two-way (2)
Not sold separately
3
  • Pin terminal, #20-22 AWG (4)
Not sold separately
4
Cable strap (6)
10006