Inner Fairing Trim Panels

J058732014-09-29

GENERAL

Kit Number

61400251, 61400283, 61400334

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Kit Contents

See Figure 2 and Table 1.

INSTALLATION

Ambient temperature should be between 21 °C (70 °F) and 38 °C (100 °F) for proper adhesion. Do not apply below 10 °C (50 °F) .
Allow AT LEAST 24 hours after application before exposing the area to vigorous washing, strong water spray or extreme weather.
The adhesive bond will increase to maximum strength after about 72 hours at normal room temperature.

NOTE

Do not clean with denatured alcohol, mineral spirits or other solvents. Damage to components may occur.

Using a 50:50 isopropyl alcohol/water solution, thoroughly clean the dash panel surfaces surrounding the dash switches and beneath the ignition switch knob. Also clean the surfaces of the media door and its mirror image molded into the left side of the inner fairing.

NOTE

The parts cannot be repositioned after initial installation.

See Figure 1. Get the media door trim panel. With the adhesive backing still in place, position the panel over the media door. Hold the panel in position and apply a small piece of masking tape along its outer edge.

1	Tape-Media Door Trim Panel
2	Tape-Inner Fairing
3	Alignment marking

Figure 1. Media Door Trim Panel Alignment

Apply a second piece of masking tape to the inner fairing next to the first piece of tape.

Draw an alignment mark across both pieces of tape.

Remove the panel and then remove its adhesive backing.

Position the panel by aligning the marks and install the panel to the media door.

Apply firm, sliding pressure across the entire panel to make sure that there is good adhesion to the media door.

Remove the masking tape.

Repeat the same general procedure for all of the parts in the kit.

SERVICE PARTS

Figure 2. Service Parts

Table 1. Service Parts Table

Item	Description (Quantity)	Part Number
1	Ignition switch trim panel	Not Sold Separately
2	Switch trim panel, right side	Not Sold Separately
3	Switch trim panel, left side	Not Sold Separately
4	Media door trim panel	Not Sold Separately
5	Inner fairing trim panel	Not Sold Separately