Front Fender Medallions
Kit Number
14100747 (bar & shield), 14100748 (H-D), 14100749 (skull)
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of (English only).
Kit Contents
See Figure 1 and Table 1.
To avoid exposure to grease, oil, dust, dirt and skin oil, the protective film must not be removed from the pressure sensitive adhesive backing until the moment of application.
Harley-Davidson cannot verify the results when affixing this medallion to any other surface or material. Improper fit or damage to surfaces may occur.
Prepare the Fender Skirt
For maximum adhesive bond, the fender skirt under and immediately surrounding the medallion must be clean and dry.
  1. Clean the surface with a mixture of 50 to 70% isopropyl alcohol and 30 to 50% distilled water.
  2. Allow fender to dry thoroughly.
To prevent contamination, apply medallion within minutes.
Apply the Medallion
  1. With the protective film still in place, trial fit the medallion to the fender skirt.
  2. NOTE
    Ambient temperature should be 70-100 °F (21-38 °C).
  3. Remove the protective film.
  4. Carefully locate and center the medallion on the fender skirt.
  5. Press the medallion firmly into position. Without shifting the medallion on the fender skirt, push hard with thumbs for about five seconds.
  6. After releasing pressure, avoid direct contact with the medallion for at least 20 minutes.
  7. NOTE
    Allow AT LEAST 24 hours before exposing the fender skirt to vigorous washing, strong water spray or extreme weather. The adhesive bond will increase to maximum strength after about 72 hours at normal room temperatures.
Figure 1. Fender Skirt Medallions
Table 1. Service Parts
Description (Quantity)
Part Number
Fender skirt medallion (2)
Not sold separately