Kit Number
42400016, 42400017, 42400018
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
Kit Contents
See Table 1.
  1. Removal procedures for this kit are the same as the original equipment (OE) removal installation procedures in the service manual front wheel removal instructions.
For CVO models: Remove stock wheel speed sensor cover. Use of a small soft mallet may be required.
  1. Save the ABS wheel speed sensor (WSS) and discard stock wheel spacer(s).
  1. For ABS equipped motorcycle models:
    1. Place ABS wheel speed sensor on a stable block of wood.
    2. See Figure 1. (1) Position ABS sensor cover on sensor with slot lined up to wire connection.
    3. Use masking tape or clean cloth to protect the finish on sensor cover.
    4. Place a block of wood on cover and with a soft mallet, tap cover onto sensor until sensor cover is (2) flush with sensor or (3) seated with slight protrusion of sensor.
  2. For all models: Installation instructions are the same as OE. See service manual for front wheel installation instructions.
1Sensor cover position
2Sensor cover seated flush with sensor
3Sensor cover seated with slight protrusion of sensor
Figure 1. ABS Sensor Cover
Table 1. Kit Contents
Kit Number
Vehicle Left Side Part
Vehicle Right Side Part
Touring ABS
Stamped cover
Domed spacer
Touring non-ABS
Tapered spacer
Tapered spacer
Softail ABS
Stamped cover
Tapered spacer