DYNA® SERVICE FRAME KITS
J065702019-09-03
GENERAL
Kit Numbers
47745-06B, 47748-10A, 47760-10A
Models
These kits are designed to update the 2010-2011 Dyna frame.
Additional Parts Required
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for this year and model motorcycle is required for this installation. One is available from a Harley-Davidson dealer.
The recommendation is that this kit be installed by a factory trained technician at an authorized Harley-Davidson Dealer.
Kit Contents
See Table 1.
INSTALLATION
NOTE
Prior to installing the new frame, verify that the VIN number matches the original frame VIN number.
After completing the installation of this frame kit, the original frame head stock that contains the Vehicle Identification Number (VIN), along with a as much of the front down tubes and 12.0 inches of the backbone from the headstock MUST be returned to your local Harley-Davidson dealer. (There may be situations that require the entire frame to be returned, but only when instructed by Technical Services). If the entire frame is returned without prior Harley-Davidson authorization, the dealer will not receive credit for the freight costs for the entire frame. Your new frame will have the correct VIN number stamped on the headstock.
Refer to your model and year service manual for procedures to remove all components from your frame. Then refer to the service manual and install all of the removed components onto the frame included in this kit. All parts included in this kit must be used to replace original parts per the Service Parts Table usage.
NOTE
Figure 2 2004 - 2008 Dyna models require modification of wire harness caddy when reusing Original Equipment (OE) tank. 2009 - 2017 Dyna models or have newer tank, modification is not required.
SERVICE PARTS
Figure 3. Service Parts for Dyna Frame Kit
Table 1. Service Parts Table
Kit | Item | Description | Part Number |
|---|---|---|---|
All Kits | 1 | Frame w/ bearing cups and Vehicle Identification Number (VIN) | Not sold separately |
2 | Clip, wire saddle | 69200082 | |
3 | Cup, bearing (2) | Not sold separately | |
4 | Plug, steering head, right | 11580A | |
Plug, steering head, left | 12100021 | ||
5 | Screw (2) | 10200036 | |
6 | Bracket, mounting | 47200009 | |
7 | Plug, press fit (2) | 12100002 | |
13 | Fastener, push-in (2) | 11785 | |
47745-06B | 8 | Nut (2) | 7880 |
9 | Washer (2) | 6792 | |
10 | Stud, shock (2) | 54666-08 | |
11 | Washer (4) | 6113 | |
12 | Nut, acorn (2) | 8185 |