1. | Loosen screw from original equipment headlamp trim ring and remove ring. Set mounting ring aside. | |||||||
2. | See See Figure 1. Assemble trim ring (1) over three headlamp mounting tabs (2). | |||||||
3. | Orient trim so clamp feature is at approximately 15 degrees to the right of bottom. | |||||||
4. | Rotate trim so clamp feature (3) is at bottom. Verify trim engages all three tab locations. Tighten. Torque: 1.3 N·m (12 in-lbs) |
Figure 1. Trim Ring Figure 2. Kit Contents |
Item | Description | Part Number |
---|---|---|
1 | Screw | 10200631 |
2 | Trim ring | Not Sold Separately |