2004 DYNA TANK BRA KIT
J028952020-09-19
General
This kit is designed for installation on 2004 Dyna model motorcycles with Orignal Equipment fuel tank.
Table 1. Kit Contents
Qty
Description
Part Number
1
Bra, fuel tank (Dyna)
62028-04
NOTE
A service manual for your motorcycle is available at your Harley-Davidson Dealer.
Installation
NOTE
To avoid scratching the fuel tank finish, first wash and wax tank. Before placing bra on tank, check to make sure that the bra liner is free from any foreign objects that may scratch the tank surface.
NOTICE
When polishing, use a clean, non-abrasive cloth and a non-abrasive polish or wax. Harley-Davidson recommends using Harley Glaze® Polish and Sealant. Abrasive polish or wax can dull or scratch the finish. (00352a)
WARNING
Improper service or maintenance of the electrical system can cause damage to the electrical system. This may result in component failure. In certain situations, a component failure during operation could lead to a loss of control, which could result in death or serious injury. (00637b)
NOTE
When performing the following step, make sure the elastic strap does not pinch or restrict the fuel tank vent hose. If the fuel tank vent hose becomes pinched or restricted, the vent hose will not vent properly.
1. See Figure 1. Beginning at the front of the tank, position the elastic strap over front edge of fuel tank against frame backbone making sure elastic strap does not pinch off fuel tank vent tube located underneath left side of tank. When properly positioned, strap will run down front of tank and along bottom toward rear of tank. Adjust, if necessary. Pull bra to the rear of tank and fit bra snugly around rear of tank.
2.
NOTE
When performing the following step, route the elastic strap and steel “S’ hook between the main wiring har-ness and the frame backbone. If the strap is not routedbetween the main harness and frame backbone, the hook could eventually cut into main harness wiring causing electrical system failure which could result indeath or serious injury.
Position the rear elastic strap around the frame backbone making sure the strap and “S” hook, when fastened, pass between the main wiring harness and frame backbone.
3. Smooth out any wrinkles in bra.
NOTE
If bra becomes soaked, it should be removed and allowed to air dry.
Figure 1. Tank Bra Installed (Typical)