FRONT SPOILER KIT
J027432020-09-20
GENERAL
Kit Number
58860-04, 58882-04BDK, 58882-XXxxx
Models
These kits fit all 2004 and later Sportster® models. These front spoilers are incompatible with engine guards. See Figure 1 for kit contents.
Installation Requirements
NOTE
A service manual for your model motorcycle is available from any Harley-Davidson dealer.
INSTALLATION
NOTE
The spoiler in kit number 58882-04BDK is finished with a primer coat. Before installation, have the spoiler painted.
| 1. | Mount the motorcycle on a lift table. | |
| 2. | See Figure 1. Attach the upper front spoiler bracket (4) to the bosses on the inside front of the spoiler (1) with the two Hi-Lo screws (10) from the kit. Tighten. Torque: 1.7–2.3 N·m (15–20 in-lbs) | |
| 3. | Attach the lower front spoiler bracket (5) to the two weld nuts in the cross bar at the bottom front of the motorcycle frame with two hex head machine screws (6) and split lockwashers (7) from the kit. Torque. Torque: 41 N·m (30 ft-lbs) | |
| 4. | Remove the protective film from the back of the medallion. Carefully center the medallion on the recessed area on the front of the spoiler. | |
| 5. | Press the Bar and Shield medallion (3) firmly into position. Hold the medallion in place, pushing hard with your thumbs, for about five seconds. Take care not to shift the medallion on the spoiler. | |
| 6. | After releasing pressure, avoid direct contact with the medallion for about 20 minutes. | |
| 7. | Place a flat washer (9) on one of the pan head machine screws (8) from the kit. Position the spoiler to the front of the frame. Insert the screw through the large hole in the bottom of the spoiler and thread it into the upper front spoiler bracket, but do not fully tighten at this time. | |
| 8. | Place a flat washer on each of the two remaining pan head machine screws from the kit. Insert the screws through the slots in the bottom of the spoiler and thread them into the lower bracket, but do not tighten fully. | |
| 9. | Position the spoiler next to the vehicle frame allowing an equal amount of minimal clearance. Alternately tighten the three screws. Torque: 8 N·m (71 in-lbs) |
SERVICE PARTS
Figure 1. Service Parts: Front Spoiler Kit
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Front spoiler | Not sold separately |
2 | Hardware kit (contains items 3 through 10) | 58876-04 |
3 | Medallion, Bar and Shield | 59354-93 |
4 | Bracket, upper front spoiler | Not sold separately |
5 | Bracket, lower front spoiler | Not sold separately |
6 | Machine screw, hex head, 3/8-16 x 3/4 in (2) | 4713W |
7 | Lockwasher, split, 3/8 in (2) | 7038 |
8 | Machine screw, hex socket, 1/4-20 x 1/2 in (3) | 4365 |
9 | Flat washer, 1/4 in (3) | 6703 |
10 | Screw, self-tapping, Hi-Lo (2) | 3596 |