0/0

FLHT INNER FAIRING POUCH

J003212020-09-22

GENERAL

Kit Number

58248-96

Models

This kit is designed for installation on 1996 and later FLHT models.

Kit Contents

Table 1. Kit Contents

Description	Quantity
Pouch	1
Film strip	1

INSTALLATION

1.	Loosen three Torx screws located on front of fairing. Do not remove screws.
2.	Pull outer fairing and windshield away from inner fairing to provide sufficient clearance to slide mounting bracket on bag between windshield and inner fairing.
3.	Install clear static film on inside of windshield, centered on fairing center stud.
4.	Position mounting bracket on bag over center stud. The pouch seats on ledge of inner fairing, flush with windshield and with opening facing rider.
5.	NOTE To avoid damaging fairing, ensure that mounting bracket on pouch is flush with inner fairing before tightening Torx screws. If bracket is not flush with fairing, tightening screws could cause damage to fairing. Tighten three Torx screws on front of outer fairing. Gently pull on bag to ensure that it is properly secured in place.