PREMIUM AMERICAN FLAG KIT
J066972019-01-15
GENERAL
Kit Number
61400617
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
NOTE
Flags are not intended for highway use. The construction of these flags will not hold up to the wind speeds seen at highway speeds. These flags are designed for parade use only.
INSTALLATION
NOTE
This kit will only fit 1/2" round bar luggage racks.
| 1. | Remove adhesive backer and adhere rubber collars (2) to inside curved surface of upper and lower clamps (3,4). | |
| 2. | Place upper and lower clamps (3,4) into desired position over luggage rack. | |
| 3. | Secure clamps (3,4) with screws (5). Tighten. Torque: 4.3–6.1 N·m (3.2–4.5 ft-lbs) | |
| 4. | Install flag (1) to underside of mast (6) (as shown). | |
| 5. | Holding flat area (A) of mast (6) with wrench, tighten mast (6) in upper clamp (4). |
NOTE
Verify that flag does not obstruct reflectors, lights or license plate after installation.
SERVICE PARTS
Figure 1. Premium American Flag Kit
Table 1. Kit Contents
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Flag | 94625-98 |
2 | Collar (2) | Not Sold Separately |
3 | Bottom clamp | Not Sold Separately |
4 | Top clamp | Not Sold Separately |
5 | Screw (2) | 10200840 |
6 | Mast | Not Sold Separately |
A | Flat holding area |