LED BULLET FOG LAMP WIRING HARNESS

941005172024-02-13

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
69203216	Safety Glasses

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: LED BULLET FOG LAMP WIRING HARNESS

Table 2. Kit Contents: LED BULLET FOG LAMP WIRING HARNESS

	Item	Qty	Description	Part No.	Notes
	1	1	Wire harness	Not sold separately
	2	6	Cable strap	10006

NOTE

Verify all contents are present in the kit before installing or removing items from vehicle.

GENERAL

For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets.

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for this year/model motorcycle is required for this installation. One is available from a Harley-Davidson dealer.

Separate purchase of an LED Bullet Fog Lamp Kit and an LED Bullet Fog Lamp Mounting Kit are required for proper installation of this kit.

These items are available from a Harley-Davidson dealer.

PREPARE

WARNING

To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)

NOTE

Vehicles WITH security siren: With security fob present, turn ignition switch ON. See the service manual. After system is disarmed, turn ignition switch OFF. IMMEDIATELY remove the main fuse.
Vehicles WITHOUT security siren: See the service manual. Remove main fuse.

INSTALL

1.	Install fog lamps per instructions in LED Lamp Kit and Mounting Bracket Kit.
2.	Complete wire harness installation. a. Figure 2 Locate connector C73A (1) underneath vehicle near coolant pump. b. Connect connector from wye harness to C73A. c. Figure 1 Route LED fog lamp wires from lamps to wye harness connectors. d. Connect lamps to wye harness. (1) e. Secure lamp wiring from lamp location to wye harness with cable straps (2).

1	Connector C73A (69202285)

Figure 2. Connector C73A

COMPLETE

NOTE

To prevent possible damage to the sound system, verify that the ignition is OFF before installing the main fuse.

1.	Install main fuse. See service manual.
2.	Install seat. After installing seat, pull up on the seat to verify that it is secure. See service manual.
3.	Refer to LED Bullet Fog Lamp instructions to configure fog lamps.