BLACK XL DERBY AND PRIMARY KIT
J067962019-08-21
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) | Time |
|---|---|---|---|
12600261 | Safety Glasses, Torque Wrench |   | 1 hour |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: XL Derby and Primary Components
Table 2. Kit Contents: XL Derby and Primary Components
 | Item | Qty | Description | Part No. | Replace | Notes |
|---|---|---|---|---|---|---|
 | 1 | 6 | Screw | 10200981 | 943 | Follow torque specification and installation sequence per service manual |
| 2 | 16 | Screw | 10200979 | 4820A | Follow torque specification and installation sequence per service manual |
| 3 | 2 | Screw | 10200980 | 41191-74A | Follow torque specification and installation sequence per service manual |
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
INSTALLLATION
Remove and Replace
NOTE
- See the service manual of the year and model vehicle that the service is being performed on for the following steps.
- Follow torque specification and installation sequence per service manual for screws.
- Remove and replace each screw one at a time to maintain initial clamp load.
- Texture black touch-up pen (98605BF) or bottle (98600BF) can be used for coverage of imperfection on engine covers.
| 1. | Fully remove one Original Equipment (OE) screw. | |
| 2. | Install new black screw. | |
| 3. | Tighten screw. See service manual. | |
| 4. | Repeat steps for remaining screws. Replace screws individually following torque sequence per service manual. |