BLACK TOURING REMAINING FASTENERS
941000152019-08-22
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) | Time |
|---|---|---|---|
12600270 (Not sold separately) | Safety Glasses, Torque Wrench |   | 10 hours |
(1) Special tools or techniques required for installation
KIT CONTENTS
Figure 1. Kit Contents: Touring Fastener Components - Black
Table 2. Kit Contents: Touring Fastener Components - Black
 | Item | Qty | Description | Part No. | Replace | Notes |
|---|---|---|---|---|---|---|
 | 1 | 1 | Screw | 10200973 | 3699D | For right side only Follow torque specification and installation sequence per service manual |
| 2 | 2 | Screw | 10200974 | 3983 | Follow torque specification and installation sequence per service manual Installation requires removal of inner and outer primary |
| 3 | 1 | Screw | 10200944 | 780 | Follow torque specification and installation sequence per service manual |
| 4 | 2 | Screw | 10200946 | 4419 | Follow torque specification and installation sequence per service manual |
| 5 | 4 | Screw | 10200961 | 10200343 | Replace visible case screws only Follow torque specification and installation sequence per service manual Installation requires removal of inner and outer primary |
| 6 | 1 | Screw | 10200962 | 29269-83A | Follow torque specification and installation sequence per service manual |
| 7 | 2 | Screw | 10200964 | 3143 | Follow torque specification and installation sequence per service manual |
| 8 | 2 | Screw | 10200965 | 4916 | Follow torque specification and installation sequence per service manual |
| 9 | 2 | Screw | 10200966 | 4924 | Follow torque specification and installation sequence per service manual |
| 10 | 2 | Lockwasher | 10300198 | 7038 | |
NOTE: Screw (10200977) can be purchased separately for models equipped with Milwaukee-Eight Ventilator Air Cleaner. | ||||||
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify you are using the most current version of the instruction sheet is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
INSTALLL
Remove and Replace
NOTE
- See the service manual of the year and model vehicle that the service is being performed on for the following steps.
- Follow torque specification and installation sequence per service manual for screws.
- Remove and replace each screw one at a time to maintain initial clamp load.
- Texture black touch-up pen (98605BF) or bottle (98600BF) can be used for coverage of imperfection on engine covers.
| 1. | Fully remove one Original Equipment (OE) screw. | |
| 2. | Install new black screw. | |
| 3. | Tighten screw. See service manual. | |
| 4. | Repeat steps for remaining screws. Replace screws individually following torque sequence per service manual. |
NOTE
Items (7 and 10) to be pre-installed prior to installation.