80GRIT™ FOOTBOARD KIT - RIDER - SOFTAIL

941000392020-01-14

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾	Time
50501612, 50501613	Safety Glasses		1 hour

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Rider Footboard Components

Table 2. Kit Contents: Rider Footboard Components

Item	Qty	Description	Part No.	Notes
1	2	Footboard, rider, assembly, raw	50501622	Kit 50501612
1	2	Footboard, rider, assembly, black	50501623	Kit 50501613
2	2	Footboard, trim assembly, raw	50501818	Kit 50501612
2	2	Footboard, trim assembly, black	50501817	Kit 50501613
3	16	Screw	10200913	Kit 50501612

NOTE

Verify all contents are present in the kit before installing or removing items from vehicle.

GENERAL

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

NOTE

There may be decreased access to the jiffy stand tab on Softail models.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

REMOVE

See Figure 2. Remove footboard.

a. Remove e-clip (3), clevis pin (1), and torsion spring (2).

b. Save hardware for installation.

INSTALL

1.	Clean and inspect footboard brackets. Replace if worn, rusted or damaged.
2.	See Figure 2. Install footboard. a. Insert short end of torsion spring (2) into notch in footboard. b. While holding torsion spring (2) in place, install footboard and spring onto mounting bracket. c. Install clevis pin (1). d. Install E-clip (3).

1	Clevis pin
2	Torsion spring
3	E-clip

Figure 2. Rider Footboard Installation

NOTE

Avoid contacting chrome surfaces with abrasive materials (stones, sand, etc.) as damage will result.

REPLACE TRIM ASSEMBLY

1.	See Figure 1. Remove screws (3).
2.	Remove trim assembly (2).
3.	Clean all threadlocker from screws and threaded holes.
4.	Apply threadlocker to threads of screws.LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
5.	Install new trim assembly.
6.	Install all screws.
7.	Tighten screws.