0/0
RADIO TOUCH SCREEN PROTECTOR KIT
J057292020-08-12
GENERAL
Kit Number
91700034
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
REMOVAL
  1. Adhere a piece of tape to the film near a corner.
  2. Pull the tape to lift the film off the radio face.
INSTALLATION
  1. Thoroughly clean the surface of the face using a screen wipe and microfiber cleaning cloth included in the kit.
  2. Peel a small portion of the backing away from the new protector film. Avoid touching the contact side of the film with fingers.
    3. NOTE
    See the Installation & Care section at 3M.com for protective film application videos.
    For ease of installation, the replacement film is slightly smaller than the original film.
  3. Carefully align the film and place on the radio face.
  4. Using the included applicator as a squeegee, gradually peel the backing from the film while slowly applying the film to the radio face with the squeegee. Do not use excessive pressure when applying the film to the radio face.
  5. Work any bubble to the outer edge. If any dust became trapped under the film:
    1. Use a piece of tape to lift the film.
    2. Press the adhesive side of a second piece of tape against film to capture the dust particle.
    3. Use the squeegee to again place the film.
    6. NOTE
    The film can be removed and repositioned after installation if a dust or dirt particle is discovered.
SERVICE PARTS
Figure 1. Service Parts: Radio Touch Screen Protector Kit
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Protective film (2)
Not sold separately
2
Screen wipes
Not sold separately
3
Microfiber cleaning cloth
Not sold separately
4
Applicator
Not sold separately