TOP CASE BACKREST PAD
941000912021-04-13
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) | Time |
|---|---|---|---|
53000847 | Drill, 6.5mm drill bit, Safety Glasses, Torque Wrench, Loctite 243 Blue |  | 1 hour |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Back Rest
Table 2. Kit Contents: Back Rest
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Backrest, lower pad | Not sold separately | |
| 2 | 1 | Backrest, upper pad | Not sold separately | |
| 3 | 5 | Screw | 10201084 | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
PREPARE
WARNINGTo prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)
| 1. | Remove top case. See service manual. |
INSTALL
| 1. | Locate drill template in kit. | |
| 2. | Figure 2 Tape templates (2 and 3) onto top case as shown. | |
| 3. | Mark locations (1) where to drill. | |
| 4. | Figure 3 Drill holes in top case. Diameter: 6.5 mm (0.256 in) a. Deburr the holes. | |
| 5. | Apply threadlocker to screws.LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97) | |
| 6. | Figure 4 Install lower backrest (2). | |
| 7. | Install screws (2). | |
| 8. | Install upper backrest (1). | |
| 9. | Install screws (2). | |
| 10. | Tighten screws (2). Torque: 5.5 N·m (49 in-lbs) Backrest screw |
| 1 | Mark locations |
| 2 | Template upper |
| 3 | Template lower |
Figure 2. Template Locations
| 1 | Drilling holes |
Figure 3. Drill Top Case
| 1 | Upper backrest pad |
| 2 | Lower backrest pad |
| 3 | Screw (5) |
Figure 4. Install Backrest
COMPLETE
| 1. | Install top case. See service manual. |