CARBON FIBER EXHAUST SHIELD INSERT
941000752021-03-08
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) | Time |
|---|---|---|---|
65400648 | Safety Glasses, Torque Wrench |  | 30 minutes |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Carbon Fiber Exhaust Shield Insert
Table 2. Kit Contents: Carbon Fiber Exhaust Shield Insert
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 2 | Spacer, aluminum | 10600074 | |
| 2 | 4 | Insulating washer | 10600072 | |
| 3 | 2 | Plain washer | 10600076 | |
| 4 | 2 | Screw | 10201160 | |
| 5 | 1 | Carbon fiber insert | Not sold separately | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit.
If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation.
Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
| 1. | See Figure 2. Remove and discard screws (1). | |
| 2. | Remove OEM heat shield (2). |
| 1 | Screw (2) |
| 2 | OEM Heat shield |
Figure 2. OEM Heat Shield
INSTALL
| 1. | See Figure 3. Apply threadlocker to screws (5).LOCTITE 262 HIGH STRENGTH THREADLOCKER AND SEALANT (RED) (94759-99) | |
| 2. | Install OEM heat shield (1). | |
| 3. | Install aluminum spacers (2), insulation washers (3) and carbon fiber insert (6). | |
| 4. | Install insulation washers (3), plain washers (4) and screws (5). | |
| 5. | Tighten screws (5). Torque: 5–6.2 N·m (44–55 in-lbs) Carbon fiber insert screws |
| 1 | OEM Heat shield |
| 2 | Aluminum spacer (2) |
| 3 | Insulating washer (4) |
| 4 | Plain washer (2) |
| 5 | Screw (2) |
| 6 | Carbon fiber insert |
Figure 3. Carbon Fiber Insert