PASSENGER FOOTPEG SUPPORT KIT
941001852022-03-14
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
50502192A | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Passenger Footpeg Support Kit
Table 2. Kit Contents: Passenger Footpeg Support Kit
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Heel guard, passenger, right | 50502263 | |
| 2 | 2 | Clevis pin, rider footpeg | 50501782 | |
| 3 | 1 | Bracket, passenger, right | 50502190 | |
| 4 | 1 | Spacer, right | 50502208 | |
| 5 | 1 | Reducer, threaded | 47500051 | |
| 6 | 1 | Screw, M8 X 1.0 X 30mm TORX, with threadlocker, T45 (zinc) | 10201109 | |
| 7 | 1 | Bracket, passenger, left | 50502191 | |
| 8 | 1 | Screw, M8 X 1.25 X 60mm TORX, with threadlocker, T45 (zinc) | 10201111 | |
| 9 | 1 | Spacer, left | 50502209 | |
| 10 | 1 | Locknut | 10100045 | |
| 11 | 2 | Screw, M10 X 1.5 X 95mm TORX, with threadlocker, T50 (zinc) | 10201110 | |
| 12 | 2 | Plate | 50502231 | |
| 13 | 2 | Spring, detent | 50500706 | |
| 14 | 2 | Ball, detent | 50500707 | |
| 15 | 2 | Screw, M5 | 10201299 | |
| 16 | 1 | Cable strap | 10006 | |
GENERAL
Models
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
These items are available at your Harley-Davidson dealership:
Separate purchase of Harley-Davison Passenger Footrest Kit is required for a complete installation.
REMOVE
| 1. | Figure 2 Remove Original Equipment (OE) screws (2) from exhaust guard (1). Discard screws. |
| 1 | Exhaust guard |
| 2 | Screw (2) |
Figure 2.
INSTALL
| 1. | Figure 3 Install heel guard (1) and screws (2). Tighten. Torque: 5.2–7 N·m (4–5 ft-lbs) | |
| 2. | Figure 4 Install right footpeg bracket. a. Install reducer (3). Tighten. Torque: 86–95 N·m (63–70 ft-lbs) b. Install spacer (2), footpeg bracket (1) and long screw (5). c. Install long screw (5) and locknut (4). d. Tighten screws. Torque: 41 N·m (30 ft-lbs) | |
| 3. | Figure 6 Install cable strap (1) around brake lines. a. Verify that brake lines do not touch and rub against right support. b. Cut any excess length of cable strap. | |
| 4. | Figure 5 Install left footpeg bracket. a. Install spacer (4), left footpeg bracket (2) and long screw (3). b. Install short screw (1). c. Tighten screws (1,3). Torque: 35 N·m (26 ft-lbs) | |
| 5. | Install footpegs. a. See Rider Footrests in service manual. b. See Installation Requirements. |
NOTE
Table 2 Detent plate (12) allows for two different footpeg fold-up locations. Check that both left and right sides are using the same positions on detent plate to ensure similar footpeg fold-up across vehicle.
| 1 | Heel guard |
| 2 | Screw (2) |
Figure 3.
| 1 | Footpeg bracket, right |
| 2 | Spacer |
| 3 | Reducer |
| 4 | Locknut |
| 5 | Screw, long (2) |
Figure 4. Right Footpeg Bracket Install
| 1 | Screw, short |
| 2 | Footpeg bracket, left |
| 3 | Screw, long |
| 4 | Spacer |
Figure 5. Left Footpeg Bracket Install
| 1 | Cable strap |
Figure 6. Cable Strap Location