1. | Remove and discard rear spark plug wire retainer. | |
2. | See Figure 1. Install speed nut (3) through large hole with flat side facing down. a. Align threaded holes to small mounting holes in plate. | |
3. | See Figure 1. Install special nuts (4) into bottom hex hole (2). b. Insert screw (1) fully into special nut (4). c. Press special nut assembly firmly against crossmember. d. Tighten screw (1) (approximately 2-1/2 turns). Torque: 6.8 N·m (60 in-lbs) e. Remove screw (1) and washer (2). f. Repeat procedure for opposite side. | |
4. | NOTE Do not use LOCTITE® on fasteners as damage to air deflectors will occur. Position left deflector behind park plug wire and evaporative tube (if present). | |
5. | Install washers (2) and screws (1). Tighten. Torque: 2.8–3.9 N·m (25–35 in-lbs) | |
6. | Attach rear spark plug wire to left deflector cable clip (5). |
1 | Top hole, speed nut location |
2 | Bottom hex hole, special nut location |
3 | Speed nut (2) |
4 | Special nut (2) |
1 | Screw (4) |
2 | Washer (4) |
3 | Right deflector |
4 | Left deflector |
5 | Spark plug cable clip |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Screw (4) | 3787 |
2 | Flat washer (4) | 6036 |
3 | Speed nut (2) | 8108 |
4 | Special nut (2) | 8194 |
5 | Mid-frame air deflector, right (for 58167-09) | 58167-09 |
Mid-frame air deflector, right (for 58002-09A, without chassis fan) | 58002-09 | |
Mid-frame air deflector, right (for 57200157, with chassis fan) | 58167-09 | |
Mid-frame air deflector, translucent right | 57200243 | |
6 | Mid-frame air deflector, left | 58169-09 |
Mid-frame air deflector, translucent left | 57200256 |