REVOLUTION MAX - VELOCITY STACK
941001882022-03-07
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
29400433, 29400453
Safety Glasses, Torque Wrench
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Revolution Max - Velocity Stack
Table 2. Kit Contents: Revolution Max - Velocity Stack
Verify that all contents are present in the kit before installing or removing items from vehicle.
Item
Qty
Description
Part No.
Notes
1
1
Screw, flange, M6
10200899
2
2
Screw, flange, M12
10201013
3
1
Velocity stack
Not sold separately
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
REMOVE
1. See Figure 2. Remove Original Equipment (OE) right side valley cover.
a. Pull cover (1) off and discard.
2. See Figure 3. Remove right side valley cover bracket.
a. Remove small screw (2) and discard.
b. Remove large screws (1) and discard.
c. Remove bracket (3).
1Cover
Figure 2. Right Side Valley Cover
1OE Large screw (2)
2OE Small screw
3Bracket
Figure 3. Bracket
INSTALL
1. See Figure 4. Install velocity stack (3).
2. Install small screw (1). Tighten.
Torque: 5.8–7.9 N·m (51–70 in-lbs) Small screw
3. Install large screws (2). Tighten.
Torque: 108–119 N·m (80–88 ft-lbs) Large screw
1Small screw
2Large screw (2)
3Velocity stack
Figure 4. Velocity Stack