TAIL SECTION COWL
941003392021-07-09
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
61301317 | Safety Glasses |  |
(1) Only simple tools and techniques required
KIT CONTENTS
| A | Thumb position during install and removal |
Figure 1. Kit Contents: Carbon Fiber Tail Section Cowl
This kit contains one carbon fiber passenger seat cover. There are no service parts available for this kit.
GENERAL
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
Contact LiveWire Customer Support Center at 1-414-343-4122 or toll free at 1-855-EVRider (855-387-4337). Visit www.livewire.com for additional information.
Installation Requirements
NOTE
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a LiveWire dealer perform the installation. Improper installation of this kit could result in death or serious injury.
INSTALL
| 1. | Raise seat. See owner's manual. | |
| 2. | Figure 1 Install cowl. a. Align rear tab with slot at rear of seat. b. With thumbs placed near position A pull straps outward just enough to allow front of cowl to pass over seat. c. Slide cowl along seat into position while engaging tab at rear. d. Join straps under seat base and bond hook and loop material. | |
| 3. | Lower seat. Pull up on seat to verify that it is secure. See owner's manual. |