WINDSHIELD/WIND DEFLECTOR KIT
J060112022-10-17
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
57400270, 57400271, 57400279, 57400280, 57400281, 57400310, 57400526 | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
This kit contains one windshield/wind deflector.
GENERAL
NOTE
This instruction sheet may have a Supplemental Video to assist installer in clarifying a certain part of the assembly. A linked video would be located at the end of this instruction sheet.
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
REMOVE
| 1. | Figure 1 Remove two inner screws (3) and nylon washers (4). | |
| 2. | Loosen outer screws (3). | |
| 3. | Remove windshield/wind deflector. | |
| 4. | Leave rubber trim strip (2) in place. |
INSTALL
| 1. | Put windshield/wind deflector into position. | |
| 2. | Figure 1 Install mounting screws (3) with nylon washers (4). | |
| 3. | Make sure that the nylon washers are outside of windshield/wind deflector. | |
| 4. | Tighten mounting screws from center to outside edge on both sides | |
| 5. | Tighten screws. Torque: 0.9–1.3 N·m (8–12 in-lbs) |
| 1 | Windshield/Wind deflector |
| 2 | Rubber trim strip |
| 3 | Screw (4) |
| 4 | Nylon flat washer (4) |
Figure 1. Windshield/Wind Deflector Installation
MAINTENANCE
Care and Cleaning
NOTICE
Polycarbonate windshields/wind deflectors require proper attention and care to maintain. Failure to maintain polycarbonate properly can result in damage to the windshield/wind deflector. (00483e)
- Do not use benzene, paint thinner, gasoline or any other type of harsh cleaner on the windshield/wind deflector. Doing so damages the surface.
- Do not clean in hot sun or high temperature.
- Powdered, abrasive or alkaline cleanser damages the windshield/wind deflector.
- Sunlight reflections off the inside curvature of a windshield/wind deflector can, at certain times of the day, cause extreme heat build-up on motorcycle instruments. Exercise care in parking. Park facing the sun, place an opaque object over the instruments, or adjust the windshield/wind deflector to avoid reflections.
NOTE
Harley-Davidson Windshield Water Repellent Treatment (Part No. 99841-01) is approved for use on Harley-Davidson polycarbonate windshield/wind deflectors.