FORWARD CONTROL SHIFT LINKAGE
941003272023-01-19
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
33600402
Safety Glasses, Torque Wrench
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Revolution Max Forward Control Shift Linkage
Table 2. Kit Contents: Revolution Max Forward Control Shift Linkage
Verify that all contents are present in the kit before installing or removing items from vehicle.
Item
Qty
Description
Part No.
Notes
1
1
Forward control linkage, black
33600402
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
PREPARE
1. Remove main fuse
REMOVE
1. See Figure 2. Remove shifter linkage.
a. Remove screw (4).
b. Remove screw (5), washer (2) and nut (1).
c. Remove shifter link assembly (3).
2. See Figure 3. Remove OE shifter link (2) from foot shifter (1).
1Nut
2Washer
3Shifter link assembly
4Screw
5Screw
Figure 2. Shifter Link Assembly
1Foot shifter
2Shifter link
Figure 3. Foot Shifter
INSTALL
1. See Figure 3. Install shifter link (2) to foot shifter (1). Tighten.
Torque: 10–12.5 N·m (89–111 in-lbs)
2. See Figure 2. Install shifter linkage.
a. Install new shifter linkage (3).
b. Install screw (4). Tighten.
Torque: 10–12 N·m (89–106 in-lbs)
c. Install washer (2), screw (5) and nut (1). Tighten.
Torque: 24.5–30 N·m (18–22 ft-lbs)
COMPLETE
1. Install main fuse