LARGE BRAKE PEDAL KIT
J063482023-01-09
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
50600179, 50600185, 50600186, 50600463, 50600464, 50600465, 50600511, 50600512
Safety glasses, Torque wrench
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Large Brake Pedal Kit
Table 2. Kit Contents: Large Brake Pedal Kit
Item
Qty
Description
Part No.
Notes
1
1
Pad, brake pedal
Not sold separately
2
1
Trim Cover, brake pedal
Not sold separately
3
1
Brake pedal assembly, Kit
Not sold separately
4
1
Washer, Kits 50600179, 50600185, 50600186, 50600463, 50600464, 50600465
6333
Washer, offset, Kits 50600511, 50600512
6421
5
1
Locknut, acorn, Kits 50600511, 50600512
7549A
6
1
Screw, Kits 50600179, 50600185, 50600186
4278
Screw, Kits 50600463, 50600464, 50600465
10201226
Items mentioned in text, but not included in kit
A
1
Original Equipment (OE) Brake pedal
NOTE
Verify that all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
1. See Figure 1. Remove and discard previously installed brake pedal cover from foot brake lever.
INSTALL
1. Align new pad assembly over foot brake pedal (A) as shown.
2. Apply threadlocker to screw (6).LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
3. Assemble washer (4) and screw (6).
4. Thread screw (6) through hole in brake lever and into back of pad.
5. Tighten screw
Torque: 13.56 N·m (10.0 ft-lbs)
6. Kits 50600511, 50600512: Install washer (4) onto threaded stud.
7. Install locknut (5) onto threaded stud. Tighten.
Torque: 13.6 N·m (10 ft-lbs)