0/0
TOUR-PAK AND HARD SADDLEBAG MOUNT FLAG KITS
J011432023-01-09
GENERAL
Kit Numbers
94626-98, 94837-02, 94839-07, 94901-03, 61400204, 61400377, 61400723
NOTE
Flags are not intended for highway use. The construction of these flags will not hold up to the wind speeds seen at highway speeds. These flags are designed for parade use only.
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
Table 1. Kit Contents
Item
Description
Part Number
1
Wear pads (2)
Not sold separately
2
Flag mast, trunk mount
Not sold separately
3
Retainer, flag mast
Not sold separately
4
Flag, standard, trunk mount
94625-98
Flag, 100th anniversary, trunk mount
94838-02
Flag, 105th anniversary, trunk mount
94842-17
Flag, POW-MIA, trunk mount
94902-03
Flag, 110th anniversary, trunk mount
61400203
Flag, wounded warrior, trunk mount
61400376
Flag, 120th anniversary, Tour-Pak/Saddlebag
61400720
5
Rubber pad
Not sold separately
INSTALLATION
NOTE
Water may enter Tour-Paks/saddlebags with flag mast installed during inclement weather.
NOTE
Attaching a flag mast to a Tour-Pak or saddlebag without wear pads in place may result in damage to the Tour-Pak or saddlebag exterior. Periodically check to verify the flag mast remains in contact with wear pads.
1. Figure 1 Remove adhesive backing from wear pads and place on area where mast base contacts painted portion of Tour-Pak or saddlebag.
2. Attach flag mast to Tour-Pak or saddlebag.
NOTE
Attaching flag mast to Tour-Pak or saddlebag without rubber pads in place may result in damage to exterior of Tour-Pak or saddlebag.
3. Cut adhesive rubber pad in half.
4. Remove adhesive backing from rubber pads.
5. Figure 2 To stabilize flag mast laterally, place one pad on either side of flag mast bracket on inside of Tour-Pak or saddlebags.
1Wear pad
Figure 1. Flag Mast Installed on Tour-Pak
1Rubber pads
Figure 2. Rubber Pads Installed on Interior of Tour-Pak