TIE-DOWN BRACKETS FOR TOURING
J058082024-01-23
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
93500011, 93500030 | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Tie-Down Brackets
Table 2. Kit Contents: Tie-Down Bracket Kit
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 4 | Screw | 3140 | |
| 2 | 4 | Washer | 6702 | |
| 3 | 4 | Spacer | 12400240 | |
| 4 | 1 | Tie-down bracket, right | Not sold separately | |
| 5 | 1 | Tie-down bracket, left | Not sold separately | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
PREPARE
| 1. | Remove main fuse. See service manual. |
REMOVE
| 1. | Remove Original Equipment (OE) acorn nuts, screws and upright bar. a. Retain upright bar and discard acorn nuts and screws. | |
| 2. | Disconnect turn signal. |
INSTALL
FLHTCU/FLHTK/FLHX/FLHXS:
NOTE
Tie down brackets are side specific. Brackets install with tie-down slots to the rear, angling outward and down.
| 1. | Figure 2 Route OE turn signal wire through slot on new tie-down bracket (1). | |
| 2. | Connect turn signal. | |
| 3. | Figure 2 Install tie-down bracket (1), OE upright bar (A) with turn signal, spacers (4), screws (2) and washers (3). | |
| 4. | Tighten screws. Torque: 8–12 N·m (71–106 in-lbs) | |
| 5. | Tighten screws once more. Torque: 20–24 N·m (177–212 in-lbs) | |
| 6. | Repeat steps on opposite side. |
| 1 | Tie-down bracket |
| 2 | Screw (2) |
| 3 | Washer (2) |
| 4 | Spacer (2) |
| A | OE Upright bar w/ turn signal |
Figure 2. Tie-down Bracket Remove/Install (Right side shown)
COMPLETE
| 1. | Install main fuse. See service manual. |