HOG® BLASTER™ MOTORCYCLE DRYER
J048322023-07-07
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
94651-09A | Safety Glasses |  |
(1) Only simple techniques required
KIT CONTENTS
Figure 1. Kit Contents: Hog Blaster Motorcycle Dryer
Table 2. Kit Contents: Hog Blaster Motorcycle Dryer
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Air flare nozzle | Not sold separately | |
| 2 | 1 | Neoprene nozzle | Not sold separately | |
| 3 | 1 | Warm air dryer | Not sold separately | |
| 4 | 1 | Stretch hose | Not sold separately | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
OPERATION
WARNINGDo not operate dryer while standing on a wet surface or operate a dryer that is wet. Electrical shock or short circuit could occur. (00592e)
WARNINGWear eye protection when operating the dryer. Flying debris could cause serious eye injury. (00593d)
- If the dryer falls into water, unplug the dryer immediately. Do not reach into the water.
- Do not set the dryer in water or drag the cord through water.
- Inspect the cord before operating. Do not operate the dryer if the cord is damaged.
- Always unplug the dryer when not in use.
NOTE
Due to the large volume of air produced by the dryer there may be some air venting by the seams. This is normal and helps keep the unit running efficiently.
Periodically remove the filter from the bottom of the unit for cleaning.
| 1. | Move vehicle to a dry area. | |
| 2. | Plug power cord to an undamaged UL approved three conductor 16/3 extension cord. | |
| 3. | Plug extension cord into a GFCI (ground fault circuit interrupter) electrical outlet. | |
| 4. | Install stretch hose onto the unit and attach the neoprene nozzle or air flare tool to the end of the hose to control air flow when drying different areas of the vehicle. | |
| 5. | Hold the dryer by the handle and start the dryer by pushing the toggle switch up to turn the dryer on. |