Kits | Suggested Tools | Skill Level(1) |
---|---|---|
76001295, 76001296 | Safety Glasses, Torque Wrench |
Verify that all contents are present in the kit before installing or removing items from vehicle. | |||||
---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
1 | 1 | Grille assembly, left, Stage 1 Speaker | 76001142 | ||
Grille assembly, left, Stage 2 Speaker | 76001140 | ||||
2 | 1 | Stage 1 speaker, left, 6.5 inch | 76000998 | ||
Stage 2 speaker, left, 6.5 inch | 76000999 | ||||
3 | 1 | Stage 1 speaker, right, 6.5 inch | 76001010 | ||
Stage 2 speaker, right, 6.5 inch | 76001011 | ||||
4 | 1 | Grille assembly, right, Stage 1 Speaker | 76001143 | ||
Grille assembly, right, Stage 2 Speaker | 76001141 |
1. | Remove left saddlebag. See service manual. | |
2. | Remove left side cover. See service manual. | |
3. | Remove main fuse. See service manual. NOTE 2023 and 2024 (FLHX/SE) the handlebar needs to be lowered to allow for the grilles and speakers to be removed. | |
4. | See Figure 2. 2023-later (FLHX/SE): Lower handlebar. a. Make a line from handlebar (1) onto clamp to mark handlebar position. b. Loosen screws (2). c. Lower handlebar. |
1 | Handlebar |
2 | Screw (2) |
1. | See Figure 3. Remove Original Equipment (OE) speaker grille. a. Remove screw (5) and grille (4). b. Using a non-marring tool, pry clips (3) from clip openings (2). | |
2. | Remove speaker screws (6). | |
3. | See Figure 4. Remove OE speaker. a. Remove speaker (1) from fairing far enough to gain access to connectors (4). b. Disconnect connectors (4) from speaker terminals (3). | |
4. | Repeat procedure for opposite side. |
1 | Speaker |
2 | Clip opening (2) |
3 | Clip (2) |
4 | Grille |
5 | Grille screw |
6 | Speaker screw (4) |
1 | Speaker |
2 | Alignment hole |
3 | Terminal (2) |
4 | Connector (2) |
5 | Pin |
1. | See Figure 5. Orient Stage I (2, 5) or II (3, 4) speaker as shown. | |
2. | See Figure 4. Install Stage I or II speaker. a. Connect connectors (4) to speaker terminals (3). b. Install speaker (1) into enclosure. | |
3. | See Figure 3. Install speaker screws. a. Alternately secure screws (6). b. Tighten. Torque: 1–1.5 N·m (9–13 in-lbs) | |
4. | Install grille. a. See Figure 6. Verify clips (1) and gaskets (2) are in place on grille. b. See Figure 3. Install grille aligning grille clips (3) into clip openings (2). c. Install screw (5). Tighten. Torque: 1.3–1.6 N·m (12–14 in-lbs) |
1 | Left OE Speaker |
2 | Left Stage 1 speaker |
3 | Left Stage 2 speaker |
4 | Right Stage 2 speaker |
5 | Right Stage 1 speaker |
6 | Right OE Speaker |
1 | Clip (2) |
2 | Gasket |
1. | See Figure 2. 2023-later (FLHX/SE): Secure handlebar. a. Raised handlebar (1) to marked position. b. Tighten screws (2). | |
2. | NOTE To prevent possible damage to the sound system, verify that the ignition is OFF before installing the main fuse. | |
3. | Install left side cover. See service manual. | |
4. | Install left saddlebag. See service manual. | |
5. | Turn the ignition ON, but do not start the vehicle. | |
6. | Make sure that all speakers are working properly. Check that front and rear fader function is operating correctly. If not, check speaker wiring. |