FRONT FAIRING SPEAKER GRILLE KIT
941000632019-05-23
GENERAL
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVAL
NOTE
To prevent paint damage, do not pry between speaker grille and inner fairing.
Use care to not damage speaker when inserting right angle tool.
See
Figure 1. Remove speaker grille.
Method A: Carefully insert a right angle tool (3) through a hole in the grille next to one clip (1, 4).
Pull tool to release clip.
Repeat with remaining clip.
Remove speaker grille.
Method B:
Remove top air duct.
From above, reach down into speaker area. Push on tab to disengage upper clip (1).
Carefully pull near lower clip (4) to disengage. Remove grille.
Figure 1. Remove Speaker Grille
INSTALLATION
NOTE
See
Figure 2. The
new speaker grilles are side-specific.
Install the grille.
Verify that the rubber gasket is in place on perimeter of grille.
Engage tab (2) into grille opening.
Engage clips (1) in slots in inner fairing.
Push on grille in clip areas until an audible click is heard.
Repeat steps for the opposite side.
Figure 2. Install Speaker Grille
IN USE
Avoid direct contact of a pressure washer with speaker grilles. Damage to speakers can result.
SERVICE PARTS
Figure 3. Service Parts, Front Fairing Speaker Grille Kit
Table 1. Service Parts, Front Fairing Speaker Grille Kit
Item | Description (Quantity) | Part Number |
---|
1 | Grille, LH | 76000878 |
2 | Grille, RH | 76000879 |
3 | Clip (2 per grille) | 12200025 |
4 | Gasket, RH | 76000917 |
Gasket, LH | 76000918 |