0/0
SADDLEBAG SUPPORT KIT
J056942014-01-21
GENERAL
Kit Number
90200981
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
See Figure 2 and Table 2.
REMOVAL
  1. Remove saddlebag.
  2. Remove seat.
    3. NOTE
    Save all hardware for installation.
  3. Remove fasteners securing muffler to saddlebag support.
  4. See Figure 1. Remove screw (2) and flange nuts.
  5. Remove rubber isolator. Save for installation.
  6. Remove screws (3, 4).
  7. Remove saddlebag support assembly.
INSTALLATION
NOTE
See Table 1 for torque specifications.
See Figure 1. Support tube screw (1) is installed from rear to front on all models except FLHX/S.
1. See Figure 2. Install saddlebag support assembly with saved hardware.
2. Secure muffler to lower rail with screws. Tighten to 10.8–16.3 N·m (96–144 in-lbs).
WARNING
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)
3. Install seat.
Table 1. Saddlebag Support Fastener Torque Specifications
ITEM
TORQUE
1
40.7–50.2 N·m (30–37 ft-lbs)
2
20.3–27.1 N·m (15–20 ft-lbs)
3
43.4–48.8 N·m (32–36 ft-lbs)
4
43.4–48.8 N·m (32–36 ft-lbs)
1Screw, support tube-to-support casting
2Screw, support casting/support-to-fender
3Screw, saddlebag guard, upper
4Screw, saddlebag guard, lower
5Support casting
Figure 1. Saddlebag Supports
SERVICE PARTS
Figure 2. Service Parts: Saddlebag Support Kit
Table 2. Service Parts
Item
Description (Quantity)
Part Number
1
Support, saddlebag, right
90200550
2
Support, saddlebag, left
90200549