0/0
Pad Pin Replacement Kit
J017292013-11-01
GENERAL
Kit Numbers
44314-00 (black), 44324-02 (silver)
Models
These kits fits front and rear brake calipers on all Harley-Davidson model motorcycles. Kit number 44314-00 is a black pin kit and kit number 44324-02 is a silver pin kit.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
Table 1. Kit Contents 44314-00 (Black)
Quantity
Description
Part Number
2
Pad pin
44342-00
Table 2. Kit Contents 444324-02 (Silver)
Quantity
Description
Part Number
2
Pad pin
44467-02A
NOTE
A Service Manual for your motorcycle is available from your Harley-Davidson dealer.
INSTALLATION
  1. See Figure 1 and Figure 2. Remove one pad pin (12pt/0.25 in.).
    2. NOTE
    The brake pads must be pushed tight against the anti-rattle spring before the pad pins can be installed.
  2. Align the holes in the brake pad and install a new pad pin. The pad pin will make an audible click when installed.
  3. Tighten the pad pin to 180-200 in-lbs (20.3-22.6 Nm).
  4. Repeat for the other pin.
Figure 1. Front Caliper Pad Pins (12 pt/0.25 in.)
Figure 2. Rear Caliper Pad Pins (12 pt/0.25 in.)