DETACHABLE LOCKING LATCH KITS
J063452017-07-31
GENERAL
Kit Numbers
52300513, 52300514, 52300518, 52300519
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
PREPARATION
This kit converts the right latch to a locking latch to help prevent theft of the detachable accessory.
| 1. | See Figure 1. Remove detachable accessory from motorcycle. a. Pull both detent levers (3) rearward and upward. b. Each detent will stop and remain in the unlatched position. c. Remove accessory from motorcycle. | |
| 2. | Release the right latch. a. Pull detent lever rearward and allow latch to return to latched position. |
| 1 | Unlatched position |
| 2 | Latched position |
| 3 | Detent lever |
| 4 | Latch nose |
| 5 | Latch |
| 6 | Side plate |
| 7 | Detent pin |
Figure 1. Detachable Accessory Removal
LATCH REPLACEMENT
NOTE
The locking latch kit replaces the original right latch only.
| 1. | See Figure 2. Remove right latch from detachable accessory. a. Remove screw (6). b. Remove original latch assembly and washers. c. Discard original parts. | |
| 2. | Install new locking latch. a. Place new spring washer (1) and latch assembly (2) on pivot stud (A). b. Painted detachable frame: Place new small washer (4) against end of pivot stud. NOTE Chrome detachable frame does not require small washer (4). c. Install new flat washer (5) and new screw (6). Torque: 3.4–4.5 N·m (30–40 in-lbs) | |
| 3. | Return to unlatched position. a. If lock button (B) has been pushed in, unlock using the provided key. b. Pull back on lever while raising to the disengaged position. |
OPERATION
| 1. | Install detachable accessory onto motorcycle. a. As the rear of the accessory is lowered into place, the latches will automatically engage. b. When fully engaged, press lock button (B). Detachable is now secure. c. Unlock using provided key to remove accessory. |
SERVICE PARTS
Figure 2. Service Parts, Detachable Locking Latch Kits
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Spring washer | 6828 |
2 | Locking latch assembly | Not sold separately |
3 | Keys | Not sold separately |
4 | Small washer | 6912 |
5 | Flat washer | 6827 |
6 | Screw | 4569 |
Items mentioned in text | ||
A | Pivot stud | |
B | Lock button | |