1. | See Figure 1. Remove the original tail section cowl (1) cover by lifting up on the back end of the cowl. Rotate the cowl off of the post and remove it from the vehicle. |
1 | Cowl cover |
2 | Screws |
1. | See Figure 2. Remove the two rear mounting screws for the rider seat. | |
2. | Kits 52400186 and 52400204: discard the screws, Kit 52400196: retain screws for reuse. | |
3. | Install the grab strap (2), washers (4) and screws (3) in place of the original rear seat mounting screws. | |
4. | Secure two screws. Tighten. Torque: 10–12 N·m (7–9 ft-lbs) screws | |
5. | Install the pillion (1) by hooking the front tab under the mating feature on the rider seat, aligning the post and grommet and pressing down on the rear of the pillion to engage the post grommet. |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Passenger pillion seat | Not Sold Separately |
2 | Grab strap | 52400195 |
3 | Hex socket button screw (2) | 3088 |
4 | Flatwasher (2) | 6036 |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Passenger pillion seat | Not Sold Separately |
2 | Grab strap | 52400250 |
4 | Flat washer (2) | 6036 |