1 | Rear fuel tank mounting screw |
2 | Rear strap |
3 | Washer |
4 | Clip |
1 | Clip-end |
2 | Hook-and-loop tape |
3 | D-ring strap |
4 | Flange nut |
5 | Flange screw |
1. | See the owner's manual. Remove seat. | |
2. | See Figure 1. Remove the rear fuel tank mounting screw (1). Save screw. | |
3. | Attach magnetic flap of rear strap to the fuel tank as shown. | |
4. | Install the rear strap (2) and washer (3) from the kit. Secure with screw (1) from the previous step. Tighten to 24.3–29.7 N·m (18–21 ft-lbs). NOTE There are small pockets where the front straps connect to the tank bag, where the clip end of the strap can be stored. Place the clip end of each strap in a pocket while positioning the bag on the tank to prevent scratches. | |
5. | Models without Engine Guard:Models with Engine Guard: a. See Figure 2. Remove two screws, washers and radiator shroud. b. Install D-ring strap (3), flange screw (5) and flange nut (4) to engine guard mounting location. Tighten to 22.5–27.5 N·m (17–20 ft-lbs). c. Install two screws washers and shroud. Tighten screws to 9–11 N·m (80–97 in-lbs). d. Lay the bag on the tank. e. Connect the clip-end of a strap (1) to the D-ring strap. f. Repeat steps for the opposite side. g. Lay the bag on the tank. h. Route strap around the engine guard, then connect the clip-end of strap to the D-ring. i. Repeat steps for the opposite side. | |
6. | Connect the tank bag to the rear strap. Pull the strap end to tighten the strap. | |
7. | See Figure 2. Pull front strap ends to tighten straps. Secure the strap ends to the hook-and-loop tape (3). | |
WARNING After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b) | ||
8. | Install seat. |