LIVEWIRE SPEED SCREEN BLADE CARBON FIBER

J066602019-08-21

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾	Time
57400400	Safety Glasses, Torque Wrench		1 hour

(1) Tightening to torque value or other moderate tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Speed Screen Components

Table 2. Kit Contents: Speed Screen Components

	Item	Qty	Description	Part No.	Notes
	1		Speed screen, carbon fiber	Not sold separately
Items mentioned in text, but not included in kit
	A	1	Original Equipment (OE) Fairing
	B	4	OEscrew	10200721	Torque 0.5-0.65 Nm (4-6 in-lbs)

NOTE

Verify all contents are present in the kit before installing or removing items from vehicle.

GENERAL

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)

REMOVE

1.	Figure 2 Remove outer fairing (1) from grommets (2). a. Pull fairing (1) by pulling directly forward on outer edge towards front of vehicle.
2.	Figure 1 Remove OE screws (B).
3.	Remove OE wind screen (1).

INSTALL

1.	Install new carbon fiber speed screen (1) to fairing (A) using OE screws (B).
2.	Secure screws (B). tighten. Torque: 0.5–0.65 N·m (4–6 in-lbs)
3.	Figure 2 Install outer fairing (1). a. Align fairing (1) with grommets (2). b. Install fairing (1) on grommets (2).

1	Fairing
2	Grommets (4)

Figure 2. Front Fairing