DETACHABLE LUGGAGE RACK

941001672022-03-08

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
50300292	Safety Glasses, Torque Wrench, Loctite 271 Red

(1) Tightening to torque value or other moderate tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Detachable Luggage Rack

Table 2. Detachable Luggage Rack Kit

	Verify that all contents are present in the kit before installing or removing items from vehicle.
	Item	Qty	Description	Part No.	Notes
	1	1	Luggage rack, black	50300290
	2	2	Plug, black	12100205
	3	4	Nut, black	10100160
	4	8	Washer	10300242
	5	4	Screw, black	10201123
	6	1	Label	53550-00
Items mentioned in text, but not included in kit
	A	1	Upright	52300702

GENERAL

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

LOCTITE 271 HIGH STRENGTH THREADLOCKER AND SEALANT (RED) (Loctite 271)

WARNING

Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)

WARNING

Do not exceed luggage rack weight capacity. Too much weight can cause loss of control, which could result in death or serious injury. (00373a)

Maximum luggage rack weight capacity is 4.5 kg (10 lbs).

Do not use luggage rack as a seat.

INSTALL

NOTE

Cover rear fender with an H-D Service Cover or clean shop towel to prevent scratching the finish.

1.	Figure 1 Align upright (A) and luggage rack sideplate holes.
2.	Apply threadlocker to screws (5).LOCTITE 271 HIGH STRENGTH THREADLOCKER AND SEALANT (RED) (Loctite 271)
3.	Figure 1 Install screws (5), washers (4) and nuts (3).
4.	Tighten screws (5). Torque: 13.5 N·m (10 ft-lbs)