TACTICAL TREKKER-SKID PLATE
941005692024-07-17
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
49000281 | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Tactical Trekker-Skid Plate
Table 2. Kit Contents: tactical Trekker-Skid Plate
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Skid plate | Not sold separately | |
| 2 | 6 | Grommet | 12100166 | Pre-installed |
Items mentioned in text, but not included in kit | |||||
| A | 6 | Original Equipment (OE) Screw | ||
| B | 6 | OE Spacer | ||
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
REMOVE
| 1. | Remove OE skid plate. See the service manual. a. Place OE screws (A) and spacers (B) aside for future use. |
INSTALL
| 1. | Figure 2 Install OE spacer (3). |
NOTE
Spacers (3) are required to be installed from inside facing outward.
| 1. | Figure 3 Position new skid plate (1) assembly. NOTE If heat shield is present on catalyst, loosen, rotate and tighten clamps in a position were they do not interfere with skid plate or remove heat shield and clamps completely. | |
| 2. | Install all OE screws (A). Hand tighten. | |
| 3. | Verify fitment of skid plate. | |
| 4. | Tighten all screws. See the service manual. |
| 1 | Skid plate |
| 2 | Grommet (6) |
| B | OE Spacer (6) |
Figure 2. Skid Plate Assembly
| 1 | Skid plate |
| A | OE Screw (6) |
Figure 3. Install Skid Plate