RIDER FOOTBOARD KIT
J028312024-08-01
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
50631-04, 50500089, 50501801 | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rider Footboards Components
Table 2. Kit Contents: Rider Footboards Components
 | Item | Qty | Description | Part No. | Notes |
|---|---|---|---|---|---|
 | 1 | 1 | Footboard assembly, right | Not sold separately | |
| 2 | 1 | Footboard assembly, left | Not sold separately | |
| 3 | 4 | Shoulder bolt, 1/4-20 x 1-3/32 inch, Kit 50631-04 (Not shown) | 50635-82A | |
| 4 | 4 | Locknut, flanged, 1/4-20, Kit 50631-04 (Not shown) | 7716 |
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that the most current version of the instruction sheet is used. It is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
FLTRXSTSE models: Separate purchase of Front Support Mounts (Part No. 47200302A - qty of 2) is required. See service manual for removal of old front supports and install of new supports.
This kit is not compatible with Leather Rider Footboard Fringe Kits (50205-97) or (50206-98).
WARNINGRider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
| 1. | Remove two shoulder bolts and locknuts attaching existing footboard to mounting brackets. | |
| 2. | Remove the footboard. | |
| 3. | Clean and inspect the footboard brackets. Replace if worn, rusted or damaged. NOTE For kit 50500089, use Original Equipment (OE) mounting hardware when installing footboards. |
INSTALL
| 1. | Install appropriate footboard (1 or 2) in place over mounting brackets. | |
| 2. | Line up the holes and install shoulder bolts (3) and locknuts (4). Tighten. Torque: 9–12 N·m (7–9 ft-lbs) | |
| 3. | Check that footboard pivots freely. | |
| 4. | Repeat procedure for opposite side. |