JIFFY STAND SENSOR KIT
941005542024-09-04
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
69203477 | Safety Glasses, Torque Wrench, Loctite (blue) |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Jiffy stand sensor
Table 2. Kit Contents: Jiffy stand sensor Kit
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Jiffy stand switch | 50126-08b | |
| 2 | 1 | Hex socket screw | 3594 | 11–14 N·m (97–124 in-lbs) Use LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) |
Items mentioned in text, but not included in kit | |||||
| A | 1 | Original Equipment (OE) Jiffy stand sub-assembly | ||
| B | 2 | OE Hex socket screw | ||
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
REMOVE
| 1. | Remove main fuse. See service manual. |
INSTALL
| 1. | Figure 1 Install the sensor (1) onto the jiffy stand (A). | |||||||
| 2. | Secure the sensor with the hex screw (2). Tighten. Torque: 11–14 N·m (97–124 in-lbs) | |||||||
| 3. | Figure 2 Route harness (1) to the jiffy stand connector (3). | |||||||
| 4. | Secure the harness connector with the clip (2). | 
Figure 2. Harness Install |
COMPLETE
| 1. | Install main fuse. See service manual. | |
| 2. | Installation requires Digital Technician II (DT II) software update from a Harley-Davidson dealer. |