RIDER BACKREST PAD
J047312025-08-06
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
51564-09A, 51631-09A, 52530-09A, 52572-09A, 52583-09A, 52900-09A, 52914-09A, 52300008, 52300732, 52300739 | Safety glasses, Hex wrench (3/16 in) |   |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rider Backrest Pad Kit
Table 2. Kit Contents: Rider Backrest Pad Kit
 | Item | Qty | Description | Part No. | Notes |
|---|---|---|---|---|---|
 | 1 | 1 | Rider backrest assembly | Not sold separately | |
| 2 | 1 | Spring | 10406 |
GENERAL
Instruction sheet is also available electronically. To verify you are using the most current version available, do one of the following:
- Go to h-d.com/isheets
- Scan QR code in upper left corner of the instruction sheet
NOTE
This instruction sheet may have a Supplemental Video to assist installer in clarifying a certain part of the assembly. A linked video would be located at the end of this instruction sheet.
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
- Separate purchase of Rider Backrest Mounting Kit (Part No. 52589-09B) is required.
PREPARE
| 1. | Install rider backrest mounting kit. Refer to Installation Requirements. |
INSTALL
| 1. | On rider backrest, compress backrest rods and spring. | |
| 2. | Insert rods into rider backrest mounting bracket. a. Select one of three holes in mounting bracket which sets height of backrest pad. |
ADJUSTMENT
| 1. | Adjust fore or aft position of backrest pad. a. Use 3/16 inch hex wrench to adjust set screw that is accessible through eyelet opening on rear of pad. b. DO NOT remove set screw because it is difficult to install. |