MOLDED GLOVE BOX LINER KIT

J058952026-01-14

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
57100270, 57100491	Safety glasses

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Molded Glove Box Liner

Table 2. Kit Contents: Molded Glove Box Liner Kit

Verify that all contents are present in the kit before installing or removing items from vehicle.
Item	Qty	Description	Part No.	Notes
1	1	Glove box liner, right	Not sold separately
2	1	Glove box liner, left	Not sold separately

GENERAL

Instruction sheet is also available electronically. To verify you are using the most current version available, do one of the following:

Go to h-d.com/isheets
Scan QR code in upper left corner of the instruction sheet

NOTE

This instruction sheet may have a Supplemental Video to assist installer in clarifying a certain part of the assembly. A linked video would be located at the end of this instruction sheet.

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)

INSTALL

NOTE

The molded glove box liners are labeled (Left and Right) for easier identification.

1.	See Figure 2 or Figure 3. Open glove box door. a. Push top of door to open.
2.	Wash inside of glove box with warm, soapy water. a. Rinse and dry thoroughly.
3.	See Figure 6 or Figure 7. Compress liner with fingers and press into glove box.
4.	Apply pressure on liner surfaces until it fits snugly inside glove box.
5.	Close glove box door.
6.	Repeat steps for opposite side.

Figure 2. Push Top of Door to Open (Non Centered-Cooled)

Figure 3. Push Top of Door to Open (Centered-Cooled)

Figure 4. Glove Box Door Open (Non Centered-Cooled)

Figure 5. Glove Box Door Open (Centered-Cooled)

Figure 6. Install Liner into Glove Box (Non Centered-Cooled) (Right Side Shown)

1	Liner
2	Glove box

Figure 7. Install Liner into Glove Box (Non Centered-Cooled) (Right Side Shown)