Footpeg Kit
J063352016-03-08
GENERAL
Kit Number
50500533, 50500535, 50500536, 50500540, 50500655, 50500678
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 3 and Table 1.
Installation Requirements
Loctite® 243 Threadlocker and Sealant - Blue (Part No. 99642- 97) to install replacement wear tips.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
INSTALLATION
1.
Remove the hardware fastening the stock footpeg to the motorcycle footpeg support. Save the hardware for installation of new footpegs.
2.
Remove the existing footpegs and spring washers. Note the orientation of, and save, the spring washers for installation.
NOTE
See Figure 1. When installing the footpeg support mount on the motorcycle footpeg support make sure the spring washer (1) is positioned inside of the footpeg support with the square edge toward the inside of the support.
3.
Install the new footpeg mount in reverse order of stock footpeg mount removal. Place a spring, along with the mount end of the footpeg, inside the slots of the footpeg supports.
NOTE
Secure each footpeg mount and spring washer with the screw and locknut removed earlier. Tighten the locknuts to 26 N·m (19 ft-lbs).
WARNING
Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a)
4.
See Figure 1. For each footpeg, position the footpeg as desired, then tighten the adjusting screw (1) to 29 N·m (21 ft-lbs).
Wear Tip Replacement
NOTE
Refer to the service manual for the wear tip orientation.
  1. See Figure 2. Remove existing wear tip from footpeg.
  2. Apply 2 or 3 drops of Loctite 243 Threadlocker and Sealant (Blue) to the threads of the new wear tip and install to the footpeg.
  3. Tighten wear tip to 8.1–12.2 N·m (6–9 ft-lbs).
1Spring washer
2Straight edge
3Footpeg mount support
Figure 1. Vintage White Footpeg Spring Washer Installation
Figure 2. Footpeg Adjusting Screw
Service Parts
Figure 3. Service Parts
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Rubber foot peg (1)
Not sold separately
2
Socket head cap screw (1)
Not sold separately
3
Foot peg base (1)
Not sold separately
4
Foot peg wear peg (1)
50500514
5
Chrome medallion grip (2)
14100879
6
Long black foot peg mount (1)
Not sold separately