BURST COLLECTION RIDER FOOTBOARD KIT
J056342012-09-06
GENERAL
Kit Number
50500244
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
NOTE
There may be decreased access to the jiffy stand tab on Softail models.
Service Manual Required
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
1. Remove the two hinge bolts and locknuts attaching the existing footboard to the mounting brackets, and remove the footboard. Save the hardware for installation.
2. Clean and inspect the footboard brackets, and replace if worn, rusted or damaged.
3. See Figure 1. Set the correct footboard in place over the mounting brackets. Align the holes and install the pivot screws and nuts removed in Step 1. Nuts should be on the inboard side.
4. Tighten to 9–12 N·m (60–80 in-lbs).
5. Check that the footboard pivots freely on the hinge bolts.
6. Repeat for the opposite side.
Figure 1. Service Parts: Burst Collection Rider Footboard
Table 1. Service Parts Table
Item
Description (Quantity)
Part
Number
1
Footboard assembly, right
50500271
Footboard assembly, left (not shown)
50500272
2
Rubber insert, right
50500257
Rubber insert, left (not shown)
50500258
3
Footboard trim, right
Not Sold Separately
Footboard trim, left (not shown)
Not Sold Separately
4
Footboard pan, right
Not Sold Separately
Footboard pan, left (not shown)
Not Sold Separately
5
Screw, #10-24 x 5/16 in (8)
Not Sold Separately