TOURING WRAPPED FRONT FENDER KIT
J063432016-04-18
GENERAL
Kit Number
58900196
Models
This kit fits 2014 and later Touring vehicles.
Kit Contents
See Figure 1 and Table 1.
NOTE
This instruction sheet references Service Manual information. A Service Manual for your motorcycle is available from a Harley-Davidson Dealer.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
  1. Remove the front fender. See the service manual.
    1. If equipped, disconnect fender tip light wire at steering head.
    2. Remove hardware that holds fender in place and remove fender.
INSTALL
  1. Install new fender using screws and flanged locknuts supplied in kit. See the service manual.
    1. Install fender with the hem to the front and smooth inner surface toward the rear.
    2. When tightening, verify that fender to tire clearance is the same in the front and rear.
SERVICE PARTS
Figure 1. Service Parts: Touring Wrapped Front Fender Kit
Table 1. Service Parts: Touring Wrapped Front Fender Kit
Item
Description (Quantity)
Part Number
1
Socket head screws (4)
10500015
2
Flange locknuts (4)
7531
3
Fender
Not Sold Separately